Specify custom packages from fifteen basic sizes as follows:
1. Generate model number:
(A) Case Size, case sizes are determined by first 3 digits of all model numbers
| MODEL NO. | SIZE |
| 701 | 1 11/32″(34.04) x 1 11/32″(34.04) |
| 702 | 1 1/4″(31.8) x 2 1/2″(63.5) |
| 704 | 2″(50.8) x 3″(76.2) |
| 705 | 1 1/2″(38.1) x 3 1/4″(82.6) |
| 707 | 3″(76.2) x 4 1/2″(114.3) |
| 708 | 2″(50.8) x 5″(127.0) |
| 712 | 2″(50.8) x 2″(50.8) |
| 714 | 1 3/4″(44.5) x 1 3/4″(44.5) |
| 715 | 1 1/2″(31.1) x 1 1/2″(31.1) |
| 716 | 3″(76.2) x 3″(76.2) |
| 717 | 2 1/2″(63.5) x 2 1/2″(63.5) |
| 718 | 4″(101.6) x 4″(101.6) |
| 720 | 2″(50.8) x 6″(152.4) |
| 721 | 2″(50.8) x 4″(101.6) |
| 726 | 3″(76.2) x 5″(127.0) |
| Dimensions are in inches (millimeters) |
(B) Height, overall height includes two 1/16″ thick covers. Minimum 3/4″, maximum 3″ Examples: 075=3/4 height, 250= 2 1/2″ high, 175= 1 3/4″ high
(C) Number of connectors, examples 0=none, 1, 2, 3 etc.
(D) Type of female RF connectors (4 types available) examples:0= none, 1= BNC, 2= TNC, 3= Type N, 4= SMA (3mm)
(E) Number of Feedthrus, examples 0=none, 1,2, 3 etc.
(F) Type of Feedthrus, examples 0=none 1= P-011 plain Teflon type 1.8 pf with 8-32 thread for mounting, 2= P-000 filter type, 5,000 pf with 8-32 thread for mounting.
(G) Special features, SP used to designate cutouts, slots, drilled holes, tapped holes, special finish, groove pins, etc.
2. Locate connectors and Feedthrus:
The centerline of any connector or freedthru must be located a minimum of 9/16″ from any outside corner and a minimum of 3/8″ up form the bottom or down from the top of the case, including covers. Connectors may not be closer than 3/4″ center-to-center, feedthrus 5/16″. Connectors will be centered in height on the case unless otherwise specified.
3. Complete your design
| A | B | C | D | E | F | G |
| 712 | 225 | 2 | 4 | 2 | 2 | SP |
Model 712-225-24-22-2P is a 2″ x 2″ x 2 1/4″ High case with two (2) Type SMA connectors, two (2) Filter type feedthrus, and special features.